Flap disks (ususally used on 4, 4 1/2, and 7 inch angle grinders) and flap wheels (usually used on bench and die grinders, and drills) were designed to grind down and finish welds ... in ONE step ... and leave them ready to go in about 25% of the time that you would spend with hard grinding wheels.  They are VERY aggressive!  They are also one of the best items for deburring, and for removing excess fiberglass, before you put the hardcoat on.   These wheels are designed for die grinders, to get into smaller areas.    THIS ITEM IS FOR 10 - 2" FLAP DISK.  YOU MUST INDICATE DESIRED GRIT - 60, 80, 120.  SMALLER ONE IN PICTURE.   CALL 800-631-2149 WITH ANY QUESTIONS.